FlyEngravity CDU v.2

Together with CPFlight FMC and NAV2, I bought a FlyEngravity CDU v.2.
The product is quite expansive but does not need an additional display.

It has been shipped with a good packaging and once opened it lookd very solid and robust. The feedback of the switches is very good as well as the back light. Sorry for the poor quality of the photos..

The connection is very easy: it needs the power supply and a ethernet cable. The manual is pretty clear and the process quite easy (it took me around 5 minutes to have the CDU up and running).
However note that the network connection procedure described in the manual is not correct as it assigns a static IP number to the device regardless if it is connected to a DHCP as normally happens with modern modem/routers.

It is possible to assign the CDU a dynamic IP number even if the procedure is not described in the manual.
I suggest to assign a dynamic IP to the CDU. Then associate the device to a static IP in the DHCP server.

I am planning to use the device with PMDG 737 initially. Later n with ProSim.

FlyEngravity claims that a driver for PMDG will be available soo.

MCP backlit

The MCP and the CPT EFIS have been mounted into the wooden frame sitting below the monitor.
The quality of the product is impressive compared to the 10 years old RS232 model I was using before.
The picture below shows the MCP with backlit on.

I have mounted also the auto throttle off button and the T/O GA on the left side of the MCP.
The feedback of buttons, switches and toggles is worst the money I spent for this toy.

Insallation has been very easy as well. The picture has been taken while flying with P3D v2.5 and PMDG 737.

After many years I replaced the 2 old monitors with a new one, the BENQ B2711U 4K UHD 3840x2160 pixel with IPS tecnlogy. The quality is very good but have to reduce the screen resolution with my PC and graphic card that I will replace soon.